Skip to content

DIY Project: 3D Printing a High-Speed Bladeless Fan

DIY Project: 3D Printing a High-Speed Bladeless Fan

(Image Source and 3D File: KristenForge via MakerWorld)

Bladeless fans combine modern design, safety (no exposed sharp blades), and continuous, smooth airflow. With 3D printing, it's entirely possible to design and assemble your own fan at home. This guide covers building an impressive 60 cm tall fan powered by a high-speed 120 mm fan.

Download this bladeless fan 👉 www.makerworld.com

✅ A Modular 4-Part Design

To fit most desktop 3D printers (like the Bambu Lab visible in your photo), the design is split into 4 main sections that snap or screw together:

  • The amplifier ring (top section): This is where the physics magic happens. Air is expelled through a thin peripheral slot, creating a low-pressure zone at the ring's center that draws in surrounding air (Coanda effect and air entrainment). The bright green edge strip adds an excellent finishing touch.

  • The air duct (central section): It bridges the motor base and upper ring while channeling airflow to prevent pressure loss.

  • The base body: The main lower casing features honeycomb-pattern vents. These holes allow maximum ambient air intake.

  • The detachable pedestal (bottom base): Printed in a contrasting color (dark gray), it serves as the foundation and provides access to internal components.

✅ The Detachable Base: The Electronic Heart

One of the biggest challenges in this DIY project is integrating electronics cleanly without compromising aesthetics. The detachable base design solves this brilliantly:

  • The 120 mm high-speed fan: Unlike a standard PC fan, a high-speed or server fan (capable of spinning at 3000 RPM or more) is essential. Bladeless fans require high static pressure to force air through the narrow ring ducts. The 120 mm size is ideal because it offers excellent airflow-to-footprint ratio.

  • Electronics housing: The base accommodates wiring, a jack power connector (typically 12V), and the control module.

  • User interface: The small black button on the front connects to a voltage regulator or PWM (Pulse Width Modulation) controller in the base, allowing you to smoothly vary fan speed from a gentle breeze to powerful airflow.

✅ Materials and Printing Tips

For a successful 60 cm tall build, rigidity and air-tightness are critical:

  • Material: PETG or ABS/ASA are recommended for their strength and heat resistance (a high-speed fan motor can get hot). PLA works if the fan isn't exposed to sunlight.

  • Air-tightness: Ensure the joints between all 4 pieces are perfectly sealed. A line of cyanoacrylate glue, silicone sealant, or thin foam tape can be added during final assembly to prevent pressurized air from escaping before reaching the ring.

YouTube Video
Share this article

Read also

News & trends: see all articles