Skip to content

SUNLU Filament Connector Review: The Waste-Free 3D Printing Solution

SUNLU Filament Connector Review: The Waste-Free 3D Printing Solution

If you've been 3D printing for a while, you've probably built up a collection of "scraps": those 10 or 20 meters of filament left on a spool, too little for a big project but too good to throw away. The SUNLU Filament Connector is a small heated device designed to weld two filament ends together to create a continuous spool.

YouTube video

✅ Design and Technical Specs

The device is a compact, ergonomic little box. Unlike DIY methods (lighter or soldering iron), it provides a controlled environment for melting.

  • Compatibility: 1.75 mm filament (PLA, ABS, PETG, PC, PA, etc.).

  • Interface: A simple LCD screen to adjust temperature and heating time.

  • Mechanism: A heated clamp with a grooved aluminum mold to perfectly align both strands.

Partner Link: View SUNLU Filament Connector on Amazon

Filament Connector SUNLU

✅ How It Works (Our Test Protocol)

Using it is relatively intuitive, though it takes a little practice to get a perfect weld:

  1. Prep: Cut both filament ends perfectly straight (90°).

  2. Settings: Choose the temperature based on material (e.g., 200°C for PLA).

  3. Insert: Place both ends in the guide until they touch at the center of the heating zone.

  4. Fusion: Lock the device. Once temperature is reached, apply slight manual pressure to the filaments so they fuse together.

  5. Cooling: This is the critical step. Let it cool before removing the filament to prevent it from stretching and thinning (which would cause under-extrusion).

✅ Test Results: Strengths and Weaknesses

✅ The Positives

  • Real savings: Use 100% of your spools and create custom "multicolor" filaments.

  • Adjustable temperature: Unlike budget models, electronic control lets you adapt to PETG or ABS without burning the material.

  • Strong welds: Once you get the hang of it, the joint resists extruder tension very well.

❌ The Negatives

  • The weld bead: This is the main challenge. The fusion often creates a slight bulge at the joint. If you don't sand it lightly or smooth it on exit, it can get stuck in the PTFE (Bowden) tube.

  • Learning curve: It takes a few failed attempts to understand the exact pressure to apply.

✅ Verdict: Should You Buy It?

The SUNLU Filament Connector is an excellent investment for heavy 3D printer users or anyone who hates waste. It's much safer and more precise than a manual flame weld.

Tip: Always keep a small piece of fine-grit sandpaper next to the device to smooth the joint after welding. This ensures smooth passage through your printer.

To compare materials at a glance, use our filament selection tool.

Share this article

Read also

News & trends: see all articles